Linx-technologies MDEV-xxx-NT Manual de usuario descargar pdf (Pagina 2)

Table of Contents

1 Introduction

2 Ordering Information

2 NT Series Transceiver Development Board

2 Board Objects

3 Initial Setup

3 Troubleshooting

4 The Prototyping Area

5 The TX Power Select Switch

5 The Transceiver Area

6 The Power Area

6 The Evaluation Area

8 The Range Test Area

9 The PC Control Area

10 The PC Software

13 Using the Boards as a Design Reference

13 About Antennas

14 Board Control

14 Transmitter Output Power Selection

15 Transceiver Area

15 Header Section

16 Range Test Area

16 Power Area

17 Evaluation Area

17 LEDs

18 Single Routing

19 Online Resources

Warning: Some customers may want Linx radio frequency (“RF”)

products to control machinery or devices remotely, including machinery

or devices that can cause death, bodily injuries, and/or property

damage if improperly or inadvertently triggered, particularly in industrial

settings or other applications implicating life-safety concerns (“Life and

Property Safety Situations”).

NO OEM LINX REMOTE CONTROL OR FUNCTION MODULE

SHOULD EVER BE USED IN LIFE AND PROPERTY SAFETY

SITUATIONS. No OEM Linx Remote Control or Function Module

should be modiﬁed for Life and Property Safety Situations. Such

modiﬁcation cannot provide sufﬁcient safety and will void the product’s

regulatory certiﬁcation and warranty.

Customers may use our (non-Function) Modules, Antenna and

Connectors as part of other systems in Life Safety Situations, but

only with necessary and industry appropriate redundancies and

in compliance with applicable safety standards, including without

limitation, ANSI and NFPA standards. It is solely the responsibility

of any Linx customer who uses one or more of these products to

incorporate appropriate redundancies and safety standards for the Life

and Property Safety Situation application.

Do not use this or any Linx product to trigger an action directly

from the data line or RSSI lines without a protocol or encoder/

decoder to validate the data. Without validation, any signal from

another unrelated transmitter in the environment received by the

module could inadvertently trigger the action.

All RF products are susceptible to RF interference that can prevent

communication. RF products without frequency agility or hopping

implemented are more subject to interference. This module does not

have a frequency hopping protocol built in.

Do not use any Linx product over the limits in this data guide.

Excessive voltage or extended operation at the maximum voltage could

cause product failure. Exceeding the reﬂow temperature proﬁle could

cause product failure which is not immediately evident.

Do not make any physical or electrical modiﬁcations to any Linx

product. This will void the warranty and regulatory and UL certiﬁcations

and may cause product failure which is not immediately evident.

!

1 2 3 4 5 6 7 ... 12 13

Comentarios a estos manuales

Sin comentarios